Table of Contents
Advertisement
Configuring Other Features
If your installation requires different programming than the standard factory default
settings, the following sections of this manual allow configuration of non-interface-spe-
cific settings you might require:
Configuration Using Bar Codes:
beeper and LED indicators and other such universal settings.
Reading Parameters:
and LED indicators and other universal settings.
1D Symbologies:
These settings allow you to enable/disable symbologies, set label lengths, require check
digit, etc.
Software Version Transmission
The software version of the device can be transmitted over the RS-232, Keyboard and
USB interfaces by scanning the following label.
Resetting the Product Configuration to Defaults
Restore Custom Default Configuration
If you aren't sure what programming options are in your reader, or you've changed
some options and want to restore the Custom Default Configuration that may have
been saved in the reader, scan the Restore Custom Default Configuration bar code
below. This will restore the custom configuration for the currently active interface.
General Features includes programming for scanning,
Reading Parameters include programming for scanning, beeper
Includes options concerning the bar code label types (symbologies).
Transmit Software Version
NOTE: Custom defaults are based on the interface type. Configure the
reader for the correct interface before scanning this label.
Restore Custom Default Configuration
CUSTOMIZING CONFIGURATION SETTINGS
PRODUCT REFERENCE GUIDE
31
Advertisement
Table of Contents
