Table of Contents
Advertisement
Install the first six screws according to the numbering indicated on the middle frame.
2.
Install the remaining screws and standoffs on the middle frame.
3.
Install the server drive assemblies
Before you perform this procedure, make sure that you have a No. 2 Phillips screwdriver available.
Install the server drive 1, and then install the server drive 2 by using the same procedure:
1.
Connect the SATA-power Y-cable to the drive.
a.
Insert the tabs on the drive carrier to their corresponding slots on the middle frame.
b.
Removal and replacement procedures 30
Advertisement
Table of Contents
