Removing The Buffer Motor - Canon Finisher-AK1 Service Manual

4
Parts Replacing and Cleaning > Feed Assembly > Removing the Buffer Motor > Procedure
2) Remove the Buffer Front Feed Motor [1].
• 2 Screws [2]
[2]
x2
[1]
CAUTION:
When installing the Buffer Front Feed Motor Unit, be sure to perform the following steps
to hook the belt on the pulley.
1) Hook the belt [2] of the Buffer Front Feed Motor Unit [1] on the 2 pulleys [3].
2) While keeping the condition of step 1, hook the [A] part of the belt [2] on the pulley [4]
at the finisher side.
[1]
[2]
[A]
4 Parts Replacing and Cleaning > Feed Assembly > Removing the Buffer Motor > Procedure
[2]
F-4-87
[3]
[4]
F-4-88

Removing the Buffer Motor

■ Preparation
1) Remove the Rear Upper Cover (Right).(Refer to page 4-21)
2) Remove the Rear Upper Cover (Left).(Refer to page 4-21)
3) Remove the Rear Cover.(Refer to page 4-20)
■ Procedure
1) Disconnect the Flat Cable [1].
• 1 Connector [2]
• 1 Guide [A]
[A]
4-44
[2]
[1]
F-4-89
4-44