Connecting With The High Capacity Stacker - Canon Finisher-AK1 Service Manual

11) Install the Rear Cover. (8 Screws)
12) Install the Rear Small Cover. (1 Screw)
13) Install the Shunt Cable.
• 2 Screws (RS tightening; M4x10)
x2
7
Installation > Installation Procedure > Connecting with the High Capacity Stacker
F-7-57
7 Installation > Installation Procedure > Connecting with the High Capacity Stacker

Connecting with the High Capacity Stacker

NOTE:
Be sure the power of the host machine is turned OFF and the power plug is
disconnected from the outlet.
1) Remove the 3 Face Covers of the High Capacity Stacker left side.
(The removed covers and screws will not in use anymore.)
• 4 Screws
Screw
x4
Screw
7-21
F-7-58
7-21