Canon Finisher-AK1 Service Manual page 116

4
Parts Replacing and Cleaning > Intermediate Process Tray Assembly > Removing the Neat Stack Unit (Upper) > Procedure
2) Set the Belt Retainer Shaft [1] released.
3) Turn the pulley [1] in the direction of the arrow to set the positions of the 2 ribs [A] as shown
in the figure below.
[1]
4 Parts Replacing and Cleaning > Intermediate Process Tray Assembly > Removing the Neat Stack Unit (Upper) > Procedure
[1]
F-4-130
[A]
[A]
F-4-131
4) Remove the Timing Belt [2] from the pulley [1].
[1]
[2]
5) Remove the Neat Stack Unit (Upper) [1].
• 2 Connectors [2]
• 2 Screws [3]
• 2 Pins [4]
CAUTION:
When installing/removing the Neat Stack Unit (Upper) [1], be sure to install/remove the
screw [3] while supporting the Neat Stack Unit with your hand to prevent a fall.
x2
x2
[2]
[4]
4-58
F-4-132
[1]
[4]
[3]
[3]
F-4-133
4-58