Canon Finisher-AK1 Service Manual page 122

4
Parts Replacing and Cleaning > Intermediate Process Tray Assembly > Removing the Process Tray Unit > Procedure
2. Remove the Inner Cover (Lower) [1].
• 2 Screws [2]
[1]
x2
[2]
3.Turn the dial [1] to move the Stapler [2] until it hits the rear side.
[2]
[1]
4 Parts Replacing and Cleaning > Intermediate Process Tray Assembly > Removing the Process Tray Unit > Procedure
F-4-148
F-4-149
4.Visually check that the 2 Process Bin Levers [1] have not gotten under the 2 Trailing
Edge Guide Levers [2] on the finisher side. When the Process Bin Levers are under
the Guide Levers, be sure to install the Process Tray Unit again.
[2]
[1]
4-64
[2]
[1]
F-4-150
4-64