Canon Finisher-AK1 Service Manual page 293

5
Adjustment > Auxiliary Adjustment > Adjusting Delivery Angle > Procedure
■ Procedure
1) Set DIP SW382 [1] on the switch PCB as shown in the figure below.
[1]
SW382
SW381
SW383 SW384 SW385
(-) (+)
2) Press switch SW385 [1] so that this adjustment is ready now.
SW382
SW381
SW383 SW384 SW385
(-) (+)
5 Adjustment > Auxiliary Adjustment > Adjusting Delivery Angle > Procedure
ENTER
F-5-298
ENTER
[1]
F-5-299
3) Press push switch SW384 [1] to execute setting.
SW382
SW381
SW383 SW384 SW385
(-) (+)
Setting range: -19 to +3
• In the case of lower curl: execute adjustment in - (negative) direction (delivery angle is
increased)
• In the case of upper curl: execute adjustment in + (positive) direction (delivery angle is
reduced: feeding performance is improved)
<In the case of lower curl, When take-up feed of paper occurred>
ENTER
[1]
F-5-300
F-5-301
5-122
5-122