Removing From The Connection Equipment; Removing From The Host Machine - Canon Finisher-AK1 Service Manual

4
Parts Replacing and Cleaning > Removing from the connection equipment > Removing from the Host Machine > Procedure

Removing from the connection equipment

Removing from the Host Machine

■ Preparation
1) Open the Front Cover.
■ Procedure
CAUTION:
Be sure to check that the power of the host machine and this equipment is OFF and the
power plug is disconnected from the outlet.
1) Disconnect the Shunt Cable [1] (finisher side only).
• 1 Screw [2]
4 Parts Replacing and Cleaning > Removing from the connection equipment > Removing from the Host Machine > Procedure
[1]
[2]
F-4-20
2) Free the ARCNET Cable [1] from the Wire Saddle [2].
3) Turn the tab [3] in the direction of the arrow and disconnect the ARCNET Cable [1] from the
terminal [4].
4) Remove the Rear Small Cover [1].
• 1 Screw [2]
• 2 Hooks [3]
[2]
[2]
[3]
[1]
[4]
F-4-21
[1]
[3]
F-4-22
4-18
4-18