Canon Finisher-AK1 Service Manual page 176

5
Adjustment > Basic Adjustment > Height Adjustment > Height adjustment
6) Loosen the caster's fixing nut [1] with the spanner (large) [2] in [A] direction.
[2]
CAUTION:
Insert the spanner [3] thru the opening under the saddle bottom plate [2], when
loosening the caster fixing nut [1] at the front side of the saddle finisher.
[3]
5 Adjustment > Basic Adjustment > Height Adjustment > Height adjustment
[1]
[A]
F-5-7
[1]
[2]
F-5-8
7) Rotate the adjustment bolt [1] with the spanner (small) [2]. Adjust the height (that is
measured in step 6)) to be within 83.6 +/- 0.3mm.
• To raise the height: rotate in [A] direction
• To lower the height: rotate in [B] direction
(Amount of height change per rotation: approx. 1.75mm)
[A]
[2]
8) Tighten the fixing nut [1] in [B] direction.
[B]
9) Adjust the other 3 casters as well (by repeating the steps above).
10) Connect the finisher with the host machine again and check the height.
Install the covers and other parts removed in the previous steps if the height difference is
within +/- 2mm. If not, repeat the steps above to readjust the height.
5-5
[1]
[B]
F-5-9
[1]
F-5-10
5-5