Table of Contents
Advertisement
5
Adjustment > Adjustment at Time of Parts Replacement > Adjusting Staple Position (1-stapling at the rear) > Procedure
6) Check that the stapling position is within the specified range [1] of 5 +/- 2mm using this
result. If the stapling position is out of the specification, go through the procedure again
from step 2).
[1]
CAUTION:
If the LED indicates anything other than "0" meaning the adjustment failure, execute the
adjustment again.
5
Adjustment > Adjustment at Time of Parts Replacement > Adjusting Staple Position (1-stapling at the rear) > Procedure
F-5-71
5-31
5-31
Advertisement
Table of Contents
