Adjusting Position Of Stapler - Canon Finisher-AK1 Service Manual

4
Parts Replacing and Cleaning > Intermediate Process Tray Assembly > Adjusting Position of Stapler
2) Push in the Stapler [1] until it faces the direction as shown in the figure below.
3) Remove the Stapler [1].
• 2 Connectors [2]
• 2 Screws [3]
CAUTION:
Be sure to check the positioning index [4] before removing the Stapler.
[4]
[3]
4 Parts Replacing and Cleaning > Intermediate Process Tray Assembly > Adjusting Position of Stapler
[1]
F-4-139
[1]
[2]
F-4-140

Adjusting Position of Stapler

This adjustment is executed when replacing or installing/removing the Stapler in the
Intermediate Process Tray Assembly.
Adjusting method is as follows:
1) Put a marking [1] on the position of the stapler installed before replacing it.
2) Install the new stapler [2] with the marking position [1] aligned, and then secures the stapler
[2] with the 2 screws [3].
[1]
4-61
[3] [2]
F-4-141
4-61