Adjusting Side Registration Of Saddle - Canon Finisher-AK1 Service Manual

5
Adjustment > Auxiliary Adjustment > Adjusting Side Registration of Saddle > Procedure

Adjusting Side Registration of Saddle

Execute this adjustment in the case of frequent jam with the saddle stack guide.
NOTE:
The cause of jam is because the edge of feeding paper is caught in the hole of this
guide due to displacement of the saddle stack guide.
■ Preparations
1) Turn ON the power of the finisher.
2) Turn ON the power of the host machine to be on to be on standby.
3) Open the front cover and put the door switch tool into the door switch.
4) Remove the switch cover.
NOTE:
Refer to "Preparations 5-6" for details of step 1) to 4).
5 Adjustment > Auxiliary Adjustment > Adjusting Side Registration of Saddle > Procedure
■ Procedure
1) Set DIP SW382 [1] on the switch PCB as shown in the figure below.
[1]
SW382
SW381
SW383 SW384 SW385
(-) (+)
2) Press switch SW385 [1] so that this adjustment is ready now.
SW382
SW381
SW383 SW384 SW385
(-) (+)
ENTER
F-5-282
ENTER
[1]
F-5-283
5-117
5-117