Canon Finisher-AK1 Service Manual page 180

5
Adjustment > Basic Adjustment > Side Registration/Skew Adjustment > Skew adjustment
3) Loosen the 2 screws [2] on the latch base (front) [1].
4) If the value obtained at "checking adjustment value" is "+ (positive)", move it in [A] direction
and tighten the screws [2].
If the value obtained at "checking adjustment value" is "- (negative)", move it in [B] direction
and tighten the screws [2].
CAUTION:
Perform adjustment so that the total of the shifting amount (scale) of the latch base (front/
rear) is within -2 to +2 mm.
[2]
[1]
5) Loosen the 2 screws [2] on the latch base (rear) [1].
5 Adjustment > Basic Adjustment > Side Registration/Skew Adjustment > Skew adjustment
[A] [B]
F-5-20
6) If the value obtained at "checking adjustment value" is "+ (positive)", move it in [A] direction
and tighten the screws [2].
If the value obtained at "checking adjustment value" is "- (negative)", move it in [B] direction
and tighten the screws [2].
CAUTION:
Perform adjustment so that the total of the shifting amount (scale) of the latch base (front/
rear) is within -2 to +2 mm.
[A] [B]
7) Connect the finisher with the host machine.
8) Turn ON the power switch of the host machine then the finisher.
9) Check the adjustment value again.
If the adjustment value indicated on the LED is within the range, press
ENTER button to complete the adjustment mode.
If the adjustment value indicated on the LED is out of the range, execute adjustment for the
second time. Adjustment can be considered OK to complete if the value gets closer to the
adjustment range (estimated value).
10) Put the DIP switch setting back and install the removed covers/parts.
5-9
[1]
[2]
F-5-21
5-9