Canon Finisher-AK1 Service Manual page 175

5
Adjustment > Basic Adjustment > Height Adjustment > Height adjustment
3) In the case of saddle finisher, remove the saddle inner cover (lower) [1].
• 1 screw [2]
• 1 knob [3]
• 3 screws [4]
[4]
[2] [3]
5 Adjustment > Basic Adjustment > Height Adjustment > Height adjustment
[1]
[4]
F-5-4
4) Remove the 2 caster covers [1] at the left side. (the illustration shows in the case of the
saddle finisher)
• 2 screws [2]
[1]
[2]
5) Measure height [A] from the floor (where the caster is landing) to the upper surface of the
bottom plate using a scale, and check that the height is within 86.3 +/- 0.3mm.
5-4
[1]
[2]
F-5-5
[A]
86.3 0.3mm
F-5-6
5-4