Canon Finisher-AK1 Service Manual page 217

5
Adjustment > Adjustment at Time of Parts Replacement > Saddle Stitch/Fold Placement Adjustment > Saddle stitch adjustment
6) If the measured value (A, B) is within the specified range (|A-B| is 0.5mm or less), press
push switch SW385 [1] once to complete the adjustment mode. It the measured value is
out of the specified value, execute the following work.
SW382
SW381
SW383 SW384 SW385
(-) (+)
7) Work with the 2 push switches (SW383, 384) according to displacement amount for the
specified value.
Pressing SW383 [1] moves the staple position upward while pressing SW384 [2] moves the
staple position downward.
• Adjustment range: +10 to -10 (correction amount per unit: 0.125mm)
After the adjustment value is specified, go through the following procedure.
• No paper→the adjustment value is overwritten and the mode terminates.
• Paper present→re-check the staple position and go back to step 4).
5 Adjustment > Adjustment at Time of Parts Replacement > Saddle Stitch/Fold Placement Adjustment > Saddle stitch adjustment
ENTER
[1]
F-5-106
SW382
SW381
SW383 SW384 SW385
(-) (+) ENTER
[1] [2]
F-5-107
5-46
5-46