Disable or Re-enable Output
11
All control outputs (except outputs of type "Alarm devices") can be individually disabled
via menu H2/B2:
Loop unit xxxxxx output x
•
•
Control unit xx Sx
Control unit xx Rx
•
•
Control unit xx Expansion Board x output x
This is indicated by LED Fault / Disablements "General disablements" (L10). They will
remain disabled until re-enabled again via menu H2/B2.
See also chapter Output Type (H2/B3), page 117.
See also chapter "Activate / Reset Outputs (H8/S8)", page 162. An output can be activated
for an output test, even if it is disabled.
53
Operation Manual
FT1020G3 Rev 2.10.4