General Description; The Ft1020G3 Fdcie; Figure 1 Connection Diagram Of Ft1020G3 - Panasonic Brooks FireTracker FT1020G3 Operation Manual

General Description

2
2.1

The FT1020G3 FDCIE

FT1020G3 is a microprocessor controlled intelligent fire alarm system, intended for
analogue addressable detectors, as well as conventional detectors and manual call points.
Four loops are available to connect addressable units e.g. On each COM loop it is possible
to connect up to four SUB-loops.
Programmable control outputs and output units are available.
Up to 1012 addresses can be connected to each FT1020G3. Figure 1 below presents an
overview of the FT1020G3 system.
Programmable control outputs and output units are available.
FT1020G3 is available in several types e.g. large FT1020G3L and small FT1020G3S,
cabinets, versions and configurations. It can be used as a standalone FDCIE or connected
to a TLON network, i.e. in a "system", with up to 30 Control Units. Each Control Unit has
access to all information.
FT1020G3 is designed and assessed to the Australian Standard AS7240.2, AS7240.4 and
NZS4512:2010. The Fire Brigade Panel controls are incorporated as part of the front fascia
and conforms to AS4438.3.
Note: Some units are not available for the Australian market e.g. exit emergency light
MX140, aspirating unit AE2010G-P. other units are currently not approved e.g. 4466, 4585,
4464, etc.
Technical Number
The technical number, NNNNNN, is used when programming all units connected to the
COM loops. Technical number is also used to identify which unit has generated a fault. See
section 7.1, page 47.
Presentation Number
Each fire alarm point / input / zone has a presentation number, NNN-NN. The presentation
number is shown in the FDCIE display to identify the point / zone activating fire alarm. See
section 7.2, page 47.
1201

Figure 1 Connection diagram of FT1020G3

13
Operation Manual
FT1020G3 Rev 2.10.4
1202
1203