Table of Contents
Advertisement
23.6
Alert Annunciation (H2/B6)
The AA function for alarm points / zones programmed for Alert Annunciation (via EBLWin)
is normally enabled via a time channel, e.g. enabled daytime (during working hours) and
disabled night time.
As an alternative, the AA function can be continuously enabled (always on).
The AA function can be disabled via this menu (H2/B6) i.e. the AA function will be turned
off for the alarm points / zones programmed for Alert Annunciation although the time
channel is "on" or if they are programmed to be continuously enabled.
The AA function will remain off until re-enabled again via this menu.
Action
"Menu"
Scroll to menu H2.
"↲"
Scroll to menu B6.
"↲"
"↲"
"|"
Text in display
H2 Disable or re-enable
B1 Zone or Zone/Address
B2 Output
B3 Output type
B4 Alarm devices
B5 Routing equipment
B6 Alert annunciation function
Escape
menu
B6 Alert annunciation function
Disable
Alert annunciation
Disable
Alert annunciation
-- Re-enable list --------------------------------------------------
Alert annunciation off
Disable ------------------------------------
Alert annunciation
Re-enable list
Alert annunciation
off
√
123
Operation Manual
FT1020G3 Rev 2.10.4
Comments
According to chapter
"Access", see page 42.
Alert Annunciation
function can be disabled
via menu B6
Press "↲" to disable,
which will be indicated
with "√" and a beep.
The disablement will be
automatically shown in
the Re-enable list
Use the soft key "|" to
toggle between Disable
and Re-enable.
Press "↲" to re-enable.
Alert annunciation off
will disappear from the
list, indicated with a
beep.
Advertisement
Table of Contents
