Table of Contents
Advertisement
19.3.2
SSD Download to Single Control Unit
1. Start the SSD download from EBLWin as shown above. In addition to the progress
bar in EBLWin, a text message will be shown in the FT1020G3 display
"Downloading SSD". When the download is completed and the Control Unit restarts,
a fault message will be shown in the display:
FAULT: Restart Control Unit nn, code 25
DD-MM-YYYY
Code 25 indicates a normal restart after the SSD download.
2. Acknowledge the restart fault. If the download was unsuccessful, another fault will
be generated
FAULT: Site specific data (SSD), CU nn
DD-MM-YYYY HH:MM
This text message means that the SSD file has not been downloaded successfully, i.e. a
new download has to be performed.
19.3.3
SSD Download to Control Units in a TLON Network
The SSD for all Control Units can be downloaded via a PC / EBLWin, connected to one
Control Unit. The download will be performed to the Control Units, one at a time, according
to chapter "Single Control Unit" above. The download is performed in a consecutive order,
i.e. 0-1-2-3-4-......-29 amongst the selected Control Units but the Control Unit where the
PC is connected will automatically be the last one to get the SSD downloaded.
When the SSD download is completed, the Control Unit connected to the PC will
automatically restart and generate a restart fault.
19.3.4
User Definable Text messages Download
Each alarm point, zone and zone line input can have a unique user definable alarm text
programmed via EBLWin. When a fire alarm is activated e.g. an addressable alarm point,
the presentation number (Zone - Address) will be shown in FT1020G3 display and in all
the remote display units together with its alarm text.
All alarm text messages are created and downloaded via EBLWin.
A Fault message for an alarm point, zone or zone line input will also show the text message
(software ≥ V2.0.0).
HH:MM
101
Operation Manual
FT1020G3 Rev 2.10.4
Advertisement
Table of Contents
