Table of Contents
Advertisement
7. Select "Australia" for the Australian convention or "New Zealand" for NZ
convention (only for systems used in NZ).
8. Plug in EBLWin key 5094 into another available USB port
9. Go to Tools > Log on control unit, the COM port number in
displayed.
Note: First time to launch EBLWin, ensure to select "Australia and New Zealand".
If any other convention has been selected, the new 19" modules will not be shown
and can't be programmed.
19.2.5
Installation of EBL Firmware Manager
1. Unzip "EBL Firmware Manager V1.2.3" zip file and double click on the file named
EBL Firmware Manager.msi", the following dialog display:
FT1020G3 Rev 2.10.4
97
Operation Manual
Figure 21
should be
Advertisement
Table of Contents
