Table of Contents
Advertisement
7. Re-connect the webserver or gateway in the Control Unit (if any).
Note: If the downloaded S/W version is only a small bug-correction, there is no
need to follow the procedures above. If so, download S/W to one control unit at a
time, and then in the control unit, acknowledge all the 'No contact' faults.
If the software download carried out with TLON network connected, some Control Units will
not have contact with other Control Units during the downloading, the following fault may
be generated:
FAULT: Control unit nn has no contact with Control Unit nn,
network x
dd-mm-yyyy hh:mm
Since control units with new and old S/W will have different information, there will be "wrong
information" fault massages.
FAULT: Restart control unit nn has wrong information
dd-mm-yyyy hh:mm
The faults should be acknowledged.
Note: In large TLON networks, there might be a large amount of fault massages generated.
105
Operation Manual
FT1020G3 Rev 2.10.4
Advertisement
Table of Contents
