Table of Contents
Advertisement
23.1
Zone or Zone Address (H2/B1)
When a whole zone is disabled, all alarm points within the zone are disabled. Alarm points
can be individually disabled
Action
"Menu"
Scroll to menu H2.
"↵"
"↵"
"Change type of
disablements"
Write the zone number
and address
(e.g. 003, 01).
"▼"
"►"
"↲"
Text in display
H2 Disable or re-enable
B1 Zone or Zone/Address
B2 Output
B3 Output type
B4 Alarm devices
B5 Routing equipment
B6 Alert annunciation function
Escape
menu
Disable
Zone 000
Automatic re-enable:
Disable
Zone 000 address 00
Automatic re-enable:
Disable
Zone 003 address 01
Automatic re-enable:
-- Re-enable list (1) ---------------------------------------------
Zone 003 address 01 auto. re-enable at 17:05
No
Change type
of disablement
No
Change type
of disablement
√
No
Yes, at 17:05
Change type
of disablement
113
Operation Manual
FT1020G3 Rev 2.10.4
Comments
According to chapter
"Access", see page 42.
- Via menu B1, a Zone
or an alarm point (Zone
/ Address) can be
disabled.
- A time for automatic
re-enablement can be
set.
- Disabled zones and
alarm points are shown
in a Re-enable list.
Use the soft key
"Change type of
disablements" to toggle
between:
Zone 000 and
Zone 000..address 00.
Write the zone number
and address.
To set an automatic re-
enable time press "▼"
and "►". Write the time
(default is current time +
3 hours). Press "↲" to
disable, which will be
indicated with "√" and a
beep. The zone will be
automatically shown in
the Re-enable list
If the specified zone /
unit is not existing, it will
be indicated with "X"
instead of "√" and a
beep.
Use the soft key "|" to
toggle between Disable
and Re-enable list.
Advertisement
Table of Contents
