Figure 8 FT128 (or FT1020G3) Mounted in 13U Small 19" Rack Enclosure
5.2
Enclosure Components
Each 22U, 13U or 6U cabinet can be fitted with standard and optional face plates, equipment
plates, ancillary racks, etc. The available plates as follows:
•
FT1020G3 6U face plate with OWS display module integrated
19 Inch Rack equipment plate for FT1020G3 or FT128
•
•
Standard ancillary 3U rack for mounting display modules
Standard 3U blank rack to fill up the unused racks
•
•
10HP Blank cover (125 x 50 mm) to cover unused display module
4HP Blank cover (125 x 20 mm) to cover unused power monitor module
•
Standard plates for mounting MCP, 20HP Plate (125 x 100 mm)
•
•
ASE options: Romteck ASE mounting bracket, Tyco ASE mounting bracket and
Code Red ASE mounting bracket
Battery shelf 6U for 19 Inch rack cabinet
•
22U or 13U 19" rack cabinets are suitable for both FT1020G3 or FT128, each system
requires its own 6U face plate rack equipment. Choosing either system to use 22U or 13U
enclosure is dependent on the number of options added to each system. All ancillary racks
are 3U which can be fitted with every possible optional module. 1U is left opened below
both 19" rack cabinets for easy access and storage of site documentation. A 003 key is
required to open the outer acrylic door to access the controls on the panel.
5.3
New G3 Boards
5.3.1
Main Control Board 5012
The new 5012 and 5015 are redesigned with more modern components resulting in better
performance and future proof hardware. Main control board 5012 replaces 5010 and
display driver board 5015 replaces 5011 and are fully backwards compatible.
The following are some of the features:
•
Improved design with over voltage protection, improved drivers and more accurate
current limitation.
29
Operation Manual
FT1020G3 Rev 2.10.4