Activate / Deactivate Interlocking Output (H9/C2) - Panasonic Brooks FireTracker FT1020G3 Operation Manual

30.2

Activate / Deactivate Interlocking Output (H9/C2)

The output in each interlocking combination (area / point) can be manually activated via
this menu. The corresponding interlocking input will be "monitored" in the same way as if
the output was activated by its control expression.
The output in each interlocking combination (area / point) can be manually deactivated via
this menu.
Note: The output will be deactivated if its control expression still true and can't be activated
again until the control expression has been false. Also, a latched output will be deactivated.
If an interlocking output is activated via its control expression and with latching output
selected (in EBLWin), the output must be deactivated via this menu.
Action
"Menu"
Scroll to menu H9.
"↲"
Scroll to menu C2.
"↲"
Write the area number
and point (e.eg. 001
and 01.
"↲"
"|"
Text in display
H9 Interlocking outputs and inputs
C1 Activated interlocking outputs / inputs
C2 Activate / deactivate interlocking output
C3 Disable / re-enable interlocking output
C2 Activate / deactivate interlocking output
Activate
Interlocking output area: 000 point: 00
Activate
Interlocking output area: 001 point: 01
-- Deactivate list (1) ---------------------------------------------
Interlocking output area: 001 point: 01
-- Activate ----------------------------------------------------------
Interlocking output area: _ _ _ point: _ _
Deactivate list (1)
Interlocking output area: 001 point: 01
165
Operation Manual
FT1020G3 Rev 2.10.4
Comments
According to chapter
"Access", see page 42.
Write area number and
address and press "↲"
to activate, which will be
indicated with "√" and a
beep. The output will
directly be shown in the
Deactivate list.
If the specified output
√ doesn't exist, it will be
indicated with "X"
instead of "√" and a
beep.
Use the soft key "|" to
toggle between
Activate and
Deactivate list.
Select in the Deactivate
list with "▼" (in this
example there is only
one output) and press
"↲".
The deactivated output
will disappear from the
list, indicated with a
beep.