Removing, Installing The Edc Fuel Pressure Sensor - Man D2862 LE221 Repair Manual

Removing, installing the EDC fuel pressure sensor

(1) Fuel pressure sensor
Technical data
Fuel pressure sensor ............................................ M18x1.5 ............................................................47 Nm
Service products
Engine oil..................................see Maintenance Recommendations and Recommended Service Products
Important information
WARNING
Component damage due to incorrectly tightened screw/bolt connections
• If impact wrenches are used, these may only be used for pretightening to max. 50% of the
specied tightening torque
• Final tightening must always be performed manually using a torque wrench
WARNING
Restricted operation due to defective entries in the fault memory
• Before removing switches or sensors, read out and document the error memory
• Always install switches and sensors with new O-rings or sealing rings
• After installing switches or sensors, read out the fault memory and, if necessary, delete it
AE6 3st edition
ENGINE ELECTRICS
37