Man D2862 LE221 Repair Manual page 180

TURBOCHARGING
Attaching the oil pressure line
• Position the oil pressure line (2)
• Screw on and tighten union nuts (1) and (3)
Attaching the exhaust manifold
• Clean the sealing surfaces
• Position the intake manifold (3) as marked, with
jubilee clip (2) and a new O-ring
• Tighten the prole clip (2) to
Attaching the exhaust manifold
• Clean the sealing surfaces
• Position the exhaust manifold (2) with a new seal
(1)
• Screw on and tighten the mounting nuts (3)
178
15 Nm
AE6 3st edition
Attaching the charge air manifold
• Clean the sealing surfaces
• Insert a new O-ring (2) and guide band (1) into the
charge air manifold (3)
• Put on the charge air manifold (3) with a new
O-ring (5) and T-pin clamp (4)
• Tighten the T-pin clamp (4)
Attaching the vent line
WARNING
Danger of damage to property if the
hose connection is leaking
• Fit the jubilee clip as close as possible
to the bead
• Pull the vent line hose (1) onto the hose port (2)
• Attach the jubilee clip (3) with
for jubilee clips [62]
15 Nm
Hose clamp pliers