Removing, Installing The Rear Radial Shaft Seal - Man D2862 LE221 Repair Manual

CRANKSHAFT OIL SEALS

Removing, installing the rear radial shaft seal

Additional jobs
– Removing, installing the ywheel, see 315
(1) Flywheel housing
Important information
WARNING
Component damage due to inadequate positive locking of the crankshaft gear, because the
front face of the crankshaft gear is shot-peened
• The crankshaft gear must be renewed every time after the crankshaft gear screw connection is
unscrewed
WARNING
PTFE sealing rings are rendered unusable if they come into contact with oil or grease before
installation
• Clean the crankshaft gear and installer sleeve before assembly
WARNING
Component damage due to incorrectly tightened screw/bolt connections
• If impact wrenches are used, these may only be used for pretightening to max. 50% of the
specied tightening torque
• Final tightening must always be performed manually using a torque wrench
300
(2) Rear radial shaft seal
AE6 3st edition