Man D2862 LE221 Repair Manual page 179

Installing the turbocharger
Attaching the turbocharger
• Clean the sealing surfaces
• Position the turbocharger (1) with a new seal (4)
• Position the spacer sleeves (3)
• Screw on the mounting nuts (2) and tighten them
to 60 Nm
Attaching the oil return line
WARNING
Danger of damage to property if the
hose connection is leaking
• Fit the jubilee clip as close as possible
to the bead
• Clean the sealing surfaces
• Position the oil return line (2) with a new seal (1)
• Push the hose (4) with hose clamp (5) over the
tting
• Screw in and tighten the mounting bolts (3)
• Install the hose clamp (5) with
for jubilee clips [62] in the installation position
Attaching the oil pressure line ange
• Use a funnel (1) to pour clean
Attaching the oil pressure line ange
• Clean the sealing surfaces
• Position the ange (1) with a new seal (3)
• Screw in and tighten the mounting bolts (2)
Hose clamp pliers
AE6 3st edition
WARNING
If no oil is added, the turbocharger
will be damaged when the vehicle is
started for the rst time
• Fill the turbocharger with clean
oil before attaching the oil pressure line
the turbocharger (2) until the oil duct in the
turbocharger is full
TURBOCHARGING
Engine
Engine oil into
177