VIBRATION DAMPER
Removing, installing the vibration damper
Additional jobs
–
Removing, installing the cooling system, see 55
–
Removing, installing the fan V-belt, see 85
–
Removing, installing the ramfan, see 61
–
Removing, installing the intermediate ange, see 63
–
Removing, installing the fan tensioning pulley, see 89
–
Removing, installing the fan carrier with fan bearing, see 91
–
Removing, installing the poly-V-belt, see 93
– Draining the coolant, see Operator's Manual
(1) Mounting bolt
(2) Hub
Technical data
Mounting bolt ....................................................... M16x1.5x117-10.9.........................Initial torque 190 Nm
Mounting bolt ....................................................... M16x1.5x117-10.9...........................Final tightening 90°
Important information
WARNING
Component damage due to incorrectly tightened screw/bolt connections
• If impact wrenches are used, these may only be used for pretightening to max. 50% of the
specied tightening torque
• Final tightening must always be performed manually using a torque wrench
(3) Vibration damper
(4) Mounting bolt
AE6 3st edition
CRANK MECHANISM
309