Configuring Lldp - H3C S6300 Series Evb Configuration Manual

A default S-channel is created on an interface after EVB is enabled on the interface. Both SCID and SVID
are 1. After an S-channel is created, an S-channel interface or S-channel aggregate interface is created
and operates in access mode.
Do not enable both EVB and VLAN mapping, both EVB and TRILL, or both EVB and QinQ on the same
interface.
Do not create a service instance for an interface enabled with EVB, and vice versa.
Do not assign interfaces enabled with EVB and not configured with the trill evb-support command to the
same VLAN as interfaces enabled with TRILL. For more information about TRILL, see TRILL Configuration
Guide. For more information about the trill evb-support command, see TRILL Command Reference.
To enable EVB:
Step
1. Enter system view.
2. Enter Layer 2 Ethernet
interface view or Layer 2
aggregate interface view.
3. Enable EVB.

Configuring LLDP

EVB uses LLDP to transmit CDCP TLVs, and CDCP TLVs are carried by the LLDP packet that is addressed
using the Nearest non-TPMR Bridge address, so you must configure LLDP.
For detailed information about the lldp global enable, lldp enable and lldp agent nearest-nontpmr
admin-status commands, see Layer 2—LAN Switching Command Reference.
To configure LLDP:
Step
1. Enter system view.
2. Enable LLDP globally.
3. Enter Layer 2 Ethernet
interface view or Layer 2
aggregate interface view.
4. Enable LLDP on the interface
5. Configure the Nearest
non-TPMR Bridge agent for
LLDP to operate in TxRx mode.
Command
system-view
interface interface-type
interface-number
evb enable
Command
system-view
lldp global enable
interface interface-type
interface-number
lldp enable
lldp agent nearest-nontpmr
admin-status txrx
4
Remarks
N/A
N/A
By default, EVB is disabled on an
interface.
Remarks
N/A
By default, LLDP is disabled
globally.
N/A
By default, LLDP is enabled on an
interface.
The default mode is disable.