Table of Contents
Advertisement
Dionex ED50A Electrochemical Detector
2.3.1
Connectors
Recorder (Slot 2)
This analog output connector is typically used for a recorder/integrator or
diagnostic instruments. For a description of the connector pinouts, see
Table F-1 in Appendix F. For connection instructions, see Section B.6.
DS3 (Slot 2)
Disregard the DS3 connector. This connector is not required for
amperometry detection.
SRS/AES (Slot 2)
Disregard the SRS/AES connector. This connector is not required for
amperometry detection.
EC Cell
The electrochemical (amperometry) cell cable connects here.
Conductivity Cell (Slot 3)
Disregard the Conductivity Cell connector. This connector is not required
for amperometry detection.
TTL/Relay (Slot 4)
This strip of eight connectors provides an interface with other modules
(whether Dionex or non-Dionex) for TTL and relay control of the
detector. See Appendix D for a description of relay and TTL functions
and the connections between the Dionex ED50A and other modules.
60-pin Ribbon Connector (Slot 5)
The 60-pin ribbon cable to the Dionex ED50A front panel (display and
keypad) connects here.
2-8
Doc. 065551-01 6/13
Advertisement
Table of Contents
