Table of Contents
Advertisement
Dionex ED50A Electrochemical Detector
6. Save the waveform.
7. Go to the
8. Start the flow of electrolyte through the cell by starting the pump.
9. Go to the
10. Press the
11. Switch the XY plotter from standby to record. Generate cyclic
3-12
learning how to program the waveform. Contact
Technical Support for Dionex products if you notice
a problem.
ANALOG OUT SETUP
controls the EC Drive (pins 7, 10) by assigning the output change to
the potential range of your waveform. Recommended settings are:
Output: Total
Zero Position: 50%
Volts Full Scale: 1.0 V
Rise Time: 0.00 sec
Polarity: +
screen (press
DETAIL
settings:
Range: 30 nA (or as appropriate)
Ref: Ag
Cell: On
button on the front panel to start the run. Keep the
Hold/Run
X/Y plotter pen in standby at first. Adjust the Y range settings on the
XY plotter according to the Dionex ED50A readout. Readjust the
Range setting on the
to the settings on the
voltammograms.
screen (press
,
). Select the following
Menu
2
screen, if necessary. Adjust the X range
DETAIL
ANALOG OUT SETUP
,
). This screen
Menu
6
screen.
Doc. 065551-01 6/13
Advertisement
Table of Contents
