Dionex ED50A Electrochemical Detector
F.1.1
Signal Electrical Parameters
Pin 1
Pin 2
Pin 3
Pin 4
Pin 5
F-2
Attach the negative input of the chart recorder to pin 1.
Select the full-scale output range setting (0 to 0.01 V, 0 to 0.1 V, or
0 to 1.0 V) on the
ANALOG OUT SETUP
Section C.1.15).
The output resistance is 1 to 2 k.
The voltage is equal to that developed across the suppressor, where
the measured voltage equals the suppressor voltage divided by 15.
The suppressor is driven by a regulated current source.
The output resistance is 10 k.
The voltage is proportional to the Dionex DS3 heater current. The
maximum heater power produces approximately 1.2 V.
The output resistance is 5 k.
The voltage is related to the inverse exponential of the temperature.
Table F-2 lists the amperometry flow stream temperatures.
The output resistance is 1 k.
screen (see
Doc. 065551-01 6/13