Table of Contents
Advertisement
Dionex ED50A Electrochemical Detector
3.5.5
Editing an Existing Method
NOTE After you save editing changes to a method, there is no
You can modify an existing method by changing, adding, or deleting steps
and/or parameters. If you edit a method while it is running, the changes
are stored in memory when you
take effect as soon as they are saved.
To edit an existing method, go to the
number in the
Follow the instructions in the sections below. When you finish, save the
changes to the current method number or select a new number.
Changing Method Parameters
Move the cursor to the parameter field and enter a new value, using the
Dionex ED50A front panel buttons. Press
after each editing change.
Adding a Method Step
There are two ways to add a step to an existing method:
•
•
3-8
way to recall the original method. To make experimental
changes to a method while retaining the original method
in its unmodified form, save the new method (or a copy
of the original method) under a different method
number.
field, and press
EDIT
Move the cursor on the
time and parameters for the new step, and then press
arrow button. If necessary, the new step is moved to the correct
chronological point in the method.
Move the cursor on the
preceding the intended location of the new step. Press
a new, blank line below the cursor location. Enter the time and
parameters for the new step, and then press
button.
the method number. Changes
SAVE TO
screen, enter the method
METHOD
or a cursor arrow button.
Enter
Enter
screen to any
METHOD
screen to the line immediately
METHOD
Enter
or a cursor arrow button
field. Enter the
TIME
or a cursor
Enter
to insert
Insert
or a cursor arrow
Doc. 065551-01 6/13
Advertisement
Table of Contents
