Table of Contents
Advertisement
Module setup, C-18
Moduleware, 2-9, 4-9
Revision number, 3-2, C-22
N
Network
See DX-LAN network
No detector response, 4-1
Noisy baseline, 4-3
Normal edge, D-4
Normal pulse, D-4
O
Offset
Controlling with TTL input, D-6
Front panel button, 2-3
Out of range, 4-1
Selecting in a method, C-7, C-13
Offset level, C-19
Operating configuration
TTL, D-4
Operating modes, 2-14
Operation
Developing waveforms, 3-11
Preparing to run, 3-1
Running a method, 3-5
Running under Direct control, 3-4
Running under Method control, 3-5
Selecting the control mode, 3-4
Operational screens, 2-5, C-1
Ordering replacement parts, G-1
O-ring replacement, 5-4
P
Parts replacement, 5-1
See Also Service procedures
Peaks
Reversed, C-19
Tailing, 4-4
Doc. 065551-01 6/13
PEEK tubing, 5-1
pH half-cell, 2-12
pH reading, C-11, C-16
Always 7.0, 4-4
Cannot be set to 7.0, 4-5
Nonexistent, 4-5
pH reference electrode
See Reference electrode
Platinum electrodes, 2-10
Polarity
DC Amperometry mode, C-10
Integrated Amperometry mode, C-8
Selecting the output voltage polarity, C-19
Polishing working electrodes, 5-2
Potential, 4-7
Applied, 3-13
DC Amperometry mode, C-10
Integrated Amperometry mode, C-8
Potentiostat, 2-10
Power connection, B-1
Power cord
Requirements for, 2-5
Power requirements, A-1
Power supply, 2-5
Status, 2-9
Power supply card, 2-9
Power switch, 2-1
Actuator, 2-1
Power-up, 3-2
Power-Up screen, C-22
Printed circuit boards, 2-7
See also Names of cards
Problems
See Troubleshooting
Programming the voltammetry waveform, 3-13
Pulsed Amperometry mode, 1-2
R
Range
Controlling with TTL input, D-6
DC Amperometry, C-10
Integrated Amperometry, C-4
Index
Index-5
Advertisement
Table of Contents
