Table of Contents
Advertisement
Dionex ED50A Electrochemical Detector
B.4.1
Installing the DX-LAN Cable
1. Install the "combo" 10BASE-T Ethernet hub on a workbench or on
2. Plug the 10BASE-T DX-LAN cable into a 10BASE-T port on the
3. Connect the other end of the cable into the 10BASE-T DX-LAN
4. Connect a 10BASE-T cable from a 10BASE-T port on the hub to the
ED50A
(10BASE-T
Device)
Figure B-2. Example 10BASE-T Network Connections
B.4.2
Cascading Hubs
Cascading, or connecting hubs together through their 10BASE-T ports,
increases the number of ports or the number of users supported on the
network. For instructions, refer to the installation guide for the hub.
B-4
the wall. For installation instructions and site requirements, refer to
the installation guide shipped with the hub.
hub. See the example in Figure B-2.
connector on the Dionex ED50A rear panel (see Figure B-1).
10BASE-T port on the host computer's internal DX-LAN card. If the
connection is via port 8 on the hub, set the Normal/Uplink push
button to Normal.
10BASE-T
Device
10BASE-T Cables
Hub
10BASE-T
Device
10BASE-T Cable
(10BASE-T Device)
Workstation
Doc. 065551-01 6/13
Advertisement
Table of Contents
