Pattern Chorus; Chorus Parameters - Roland SH-4d Owner's Manual

PATTERN CHORUS

PATTERN CHORUS
Parameter
Ø
Type
Switch OFF, ON
Sets the parameters of the selected chorus type.

Chorus parameters

The available parameters differ depending on the type of chorus you selected in Type.
Ø
Level 0–127
Rev Send 0–127
Chorus Parameters
OFF
Turns the effect off.
Chorus
This is a stereo chorus.
Parameter Value
0–127
Rate
Depth 0–127
Feedback 0–127
CE-1
This models the classic BOSS CE-1 chorus effect unit.
It provides a chorus sound with a distinctively analog warmth.
Parameter
Intensity
SDD-320 (DIMENSION D)
This models Roland's DIMENSION D (SDD-320).
It provides a clear chorus sound.
Parameter
Mode
Delay
This is a stereo delay.
Parameter Value
Dly Sync OFF, ON
Dly Msec 1–1300
Dly Note Note
-98–+98 [%]
Feedback
200–8000 [Hz],
HF Damp
BYPASS (*1)
168
Value
"Chorus Parameters(P.168)"
Turns the chorus on/off.
"Chorus Parameters(P.168)"
Specifies the output level of the sound with chorus applied.
Specifies the send level to the reverb.
Adjusts the frequency of modulation.
Adjusts the depth of modulation.
Adjusts the level of chorus sound that's returned to the input.
Value
0–127 Adjusts the chorus depth.
Value
1, 2, 3, 4, 1+4, 2+4, 3+4
If this is ON, the delay synchronizes with the tempo.
Adjusts the delay time from the direct sound until the delay sound is heard.
Adjusts the proportion of the delay sound that is fed back into the effect. Negative (-) settings
will invert the phase.
Adjusts the frequency above which sound fed back to the effect is filtered out. If you don't want
to filter out any high frequencies, set this parameter to BYPASS.
Explanation
Explanation
Explanation
Explanation
Switches the mode.
Explanation