Ep -> Tremolo (Ep Amp Simulator -> Tremolo) - Roland SH-4d Owner's Manual

MFX Parameters
Parameter
200, 250, 315, 400, 500, 630, 800, 1000,
Dly HF 1250, 1600, 2000, 2500, 3150, 4000, 5000,
6300, 8000, BYPASS [Hz]
D100: 0W–D0: 100W
Dly Bal
Level 0–127
EP -> Tremolo (EP Amp Simulator -> Tremolo)
Parameter
Type
Bass -50–+50
Treble -50–+50
Tremolo Sw OFF, ON
OFF, ON
Tremolo Sync
T. Speed 0.05–10.00 [Hz]
T.Spd Nt Note(P.167)
Trm Depth 0–127
Trm Duty -10–+10
LINE, OLD, NEW, WURLY, TWIN
Sp Type
OD Switch OFF, ON
OD Gain 0–127
0–127
OD Drive
Level 0–127
158
Value
Value
Type of amp
OLDCASE A standard electric piano sound of the early 70s
NEWCASE A standard electric piano sound of the late 70s and early 80s
WURLY A standard electric piano sound of the 60s
Amount of low-frequency boost/cut
Amount of high-frequency boost/cut
Tremolo on/off
If this is ON, the rate synchronizes with the tempo of the rhythm.
Tempo (Pattern)
Tempo
Rate of the tremolo effect
Depth of the tremolo effect
Adjusts the duty cycle of the LFO waveform used to apply tremolo.
Type of speaker
If LINE is selected, the sound will not be sent through the speaker simulation.
Overdrive on/off
Overdrive input level
Degree of distortion
Also changes the volume.
Output Level
Negative (-) settings will invert the phase.
Frequency at which the high-frequency portion of the delay sound
will be cut (BYPASS: no cut)
Adjusts the volume balance between the sound that is sent through
the delay (W) and the sound that is not sent through the delay (D).
Output Level
Explanation
(System)(P.76)
Explanation