PAC Alcor JFTOT II Manual page 81

16. Using a piston puller, remove the piston from the
reservoir. Push the piston and piston puller out of
the top of the reservoir. Do not pull the piston.
This could damage the lip seal.
CAUTION - The lip seal is made from virgin
Teflon and is very soft. Use extreme care
®
when handling to prevent damage. A small
nick will ruin the seal and allow fuel to leak.
Botto m of
Reservoir
17. Disconnect the pre-filter section from the fuel
reservoir cover and disassemble it by removing
the three Allen screws. Discard the filter ele-
ment.
JFTOT II D3241 Manual Rev. C
18. Disconnect the water reservoir INLET and
19. Disconnect the water reservoir, push down the
Pull Down On
Reservoir Body
20. Remove the water reservoir cover and empty
Against Piston
Puller Handle.
21. Remove the glass jar from the air trap assembly
22. Pull the pan out from under the JFTOT. If the
VENT lines.
collar on the quick-connect fitting to release the
fitting. Remove the reservoir from the apparatus
and place it in a cleaning pan.
contents into the appropriate waste container, or
use the supplied quick-connect hole fitting and
allow the fuel and water in the reservoir to drain
into a waste receptacle. Opening the reservoir is
preffered because it allows you to check for post
deposits that may lie on the inside bottom surface
of the reservoir.
and empty the fuel and water in the jar into the
appropriate waste container.
pan contains fuel, check the fuel reservoir for
damage. Replace the seal if necessary and have
the pump serviced. Clean the pan and slide it
under the JFTOT.
Page 21