Main Operations - PAC Alcor JFTOT II Manual

• STEP = step or move forwards or backwards. For
example, when viewing the CUSTOM SETUP
screen, pressing STEP will display the secondary
CUSTOM SETUP screen which allows changing
flow rates and test times. Currently, this key is only
active:
a. In the secondary setup screen (CUSTOM
TEST only),
b. When viewing test histories.
• TOGGLE = change direction to move or change
value. This key is used in combination with the
STEP key. Two arrows are displayed in the top
right corner to indicate when the TOGGLE key is
active. The arrows (up/down) indicate the direction
for the STEP key (forward/backward) and the
direction for changing some values (increase/
decrease).
• PRINT SCREEN = transmits the displayed screen
to a printer or computer via the serial interface.
• REFRESH = rewrite the current display screen.
Remember, this manual is applicable to both the
JFTOT 230 and JFTOT 240. Therefore, references
and displays showing a second ∆P appear. If a test is
made using only a single ∆P, the operator should
ignore all references to the second ∆P as no informa-
tion on the second ∆P will appear on the display

3.2 MAIN OPERATIONS

When the JFTOT II power is switched ON, the
MAIN MENU is normally displayed. There are six
main operations that can be selected from the MAIN
MENU:
1. Perform a test (Custom and D3241)
2. View test data
3. Maintenance
4. AutoCal TC
5. Set clock
6. System setup
Page 10
A laminated color quick reference card is provided
(shown below) to help visualize the six main opera-
tions that can be selected from the MAIN MENU.
This card, entitled "JFTOT II OPERATIONS", can
be placed near or attached to the JFTOT for quick
reference.
JFTOT II Operation Manual Rev. C