PAC Alcor JFTOT II Manual page 71

1. If the power to the JFTOT is not on, press
POWER to turn the JFTOT ON ("I" = on, "O"=
off). The screen should display the MAIN
MENU.
2. Press F1 for the D3241 SETUP display.
3. Press F5 to confirm the drive pump is at the
bottom.
JFTOT II D3241 Manual Rev. C
4. Lubricate the lip seal with fuel. Place the piston
in the center of fuel reservoir stand. Press the
reservoir down over the piston until seated.
5. Place the O-ring in the reservoir groove.
6. Screw the filter/aeration funnel onto the top of
fuel reservoir. Place a general-purpose, retentive,
qualitative filter paper into the funnel.
7. Measure about 600 ml of fuel using a clean
graduated cylinder.
Page 11