Rear Panel Inspection; Connect To Power Source - PAC Alcor JFTOT II Manual

Accessories:
1. Power Cord
2. Filter/aeration funnel
3. Tin AutoCal Calibrator
4. Lead AutoCal Calibrator
5. Aeration dryer assembly
6. Thumb-nut Cap
7. Standardization Kit
8. Reservoir Stand
9. Pan
Lines:
1. Heater section outlet line
2. Reservoir outlet line
3. Water reservoir lines (two)
4. Pre-filter assembly
5. Time reactor line (240 only)
2.2.3 Printer Kit
A printer kit contains a printer and cable. This
printer operates on 120 VAC only. A printer
power receptacle is provided on the side of the
JFTOT to power the printer only.
2.2.4 Materials, Supplies, and Spares
Some spares and supplies are provided with the
JFTOT. Other accessories are not provided but
are required for normal operation. See MATERI-
ALS, SUPPLIES, AND SPARES in the Appen-
dix.

2.3 REAR PANEL INSPECTION

• The fluid level in the coolant reservoir should be
about 50%.
Page 6
• Check for coolant leakage, clean any spills.
• Check for loose parts and connectors. (The JFTOT
model 230 has two unused electrical connectors
located inside which are for options used on the
JFTOT model 240.)
• Install rear panel.

2.4 CONNECT TO POWER SOURCE

• Check the voltage selector switch located on the
right side. Ensure that it is toggled to the proper line
voltage, 115 or 230.
• Attach the power cord to the power connector inlet
on the side. The inlet is an IEC 320 connector
which allows using international power cords.
Connect to single-phase power, 115/120VAC at
6.25A or 220/240VAC at 6.25A, 50/60 Hz.
• Attach printer power cord to 120 VAC receptacle
on side of JFTOT.
JFTOT II Operation Manual Rev. C