Mounting An Ex3200 Switch In A Recessed Position In A Rack Or Cabinet; Mounting An Ex3200 Switch On A Wall - Juniper EX3200 Hardware Manual

EX3200 Switch Hardware Guide

Mounting an EX3200 Switch in a Recessed Position in a Rack or Cabinet

Related
Documentation

Mounting an EX3200 Switch on a Wall

150
Connecting DC Power to an EX3200 Switch on page 163
Connecting and Configuring an EX Series Switch (CLI Procedure) on page 175
Connecting and Configuring an EX Series Switch (J-Web Procedure) on page 178
Mounting an EX3200 Switch in a Recessed Position in a Rack or Cabinet on page 150
Rack-Mounting and Cabinet-Mounting Warnings on page 248
You can mount an EX3200 switch in a rack or cabinet such that the switch is recessed
inside the rack from the rack front by 2 inches. You can use the 2-in.-recess front brackets
provided in the separately orderable four-post rack-mount kit to mount the switch in a
recessed position.
Reasons that you might want to mount the switch in a recessed position include:
You are mounting the switch in a cabinet and the cabinet doors will not close completely
unless the switch is recessed.
The switch you are mounting has an uplink module with transceivers installed in it—the
transceivers in the uplink module ports protrude from the front of the switch.
To mount the switch in a recessed position on four posts, follow the instructions in
"Mounting an EX3200 Switch on Four Posts in a Rack or Cabinet" on page
the switch in a recessed position on two posts, follow the instructions in
EX3200 Switch on Two Posts in a Rack or Cabinet" on page
Connecting Earth Ground to an EX Series Switch on page 155
Rack-Mounting and Cabinet-Mounting Warnings on page 248
You can mount an EX3200 switch on a wall by using the separately orderable wall-mount
kit.
Before mounting an EX3200 switch on a wall:
Verify that the site meets the requirements described in
for EX3200 Switches" on page
Read "General Safety Guidelines and Warnings" on page
to "Chassis Lifting Guidelines" on page
Remove the switch from the shipping carton (see
page 137).
Ensure that you have the following parts and tools available:
"Site Preparation Checklist
57.
237, with particular attention
246.
"Unpacking an EX3200 Switch" on
Copyright © 2016, Juniper Networks, Inc.
146. To mount
"Mounting an
144.