Mounting An Ex3200 Or Ex4200 Switch In A Recessed Position In A Rack Or Cabinet; Mounting An Ex3200 Or Ex4200 Switch On A Wall - Juniper EX3200 Series Complete Hardware Manual

Complete Hardware Guide for EX3200 and EX4200 Ethernet Switches

Mounting an EX3200 or EX4200 Switch in a Recessed Position in a Rack or Cabinet

Related Topics

Mounting an EX3200 or EX4200 Switch on a Wall

128
Connecting and Configuring an EX Series Switch (CLI Procedure) on page 165
Connecting and Configuring an EX Series Switch (J-Web Procedure) on page 167
Mounting an EX3200 or EX4200 Switch in a Recessed Position in a Rack or Cabinet
on page 128
Rack-Mounting and Cabinet-Mounting Warnings for EX Series Switches on page 221
You can mount an EX3200 or EX4200 switch in a rack or cabinet such that the switch
is recessed inside the rack from the rack front by 2 inches. You can use the 2-in.-recess
front brackets provided in the separately orderable four-post rack-mount kit to mount
the switch in a recessed position.
Reasons that you might want to mount the switch in a recessed position include:
You are mounting the switch in a cabinet and the cabinet doors will not close completely
unless the switch is recessed.
The switch you are mounting has an uplink module with transceivers installed in it—the
transceivers in the uplink module ports protrude from the front of the switch.
To mount the switch in a recessed position on four posts, follow the instructions in
"Mounting an EX3200 or EX4200 Switch on Four Posts in a Rack or Cabinet" on page 124.
To mount the switch in a recessed position on two posts, follow the instructions in
"Mounting an EX3200 or EX4200 Switch on Two Posts in a Rack or Cabinet" on page 122.
Connecting Earth Ground to an EX Series Switch on page 141
Rack-Mounting and Cabinet-Mounting Warnings for EX Series Switches on page 221
You can mount an EX3200 or EX4200 switch on a wall by using the separately orderable
wall-mount kit.
Before mounting an EX3200 or EX4200 switch on a wall:
Verify that the site meets the requirements described in "Site Preparation Checklist
for EX3200 and EX4200 Switches" on page 87.
Read "General Safety Guidelines and Warnings for EX Series Switches" on page 207,
with particular attention to "Chassis Lifting Guidelines for EX3200 and EX4200
Switches" on page 220.
Remove the switch from the shipping carton (see "Unpacking an EX3200 or EX4200
Switch" on page 118).
Ensure that you have the following parts and tools available:
Copyright © 2010, Juniper Networks, Inc.