Mounting An Ex4200 Switch On A Wall - Juniper EX4200-24T Hardware Manual

EX4200 Switch Hardware Guide

Mounting an EX4200 Switch on a Wall

138
You can mount an EX4200 switch on a wall by using the separately orderable wall-mount
kit.
Before mounting the switch on a wall:
Verify that the site meets the requirements described in
for EX4200 Switches" on page
Read "General Safety Guidelines and Warnings" on page
to "Chassis Lifting Guidelines" on page
Remove the switch from the shipping carton (see
page 121).
Ensure that you have the following parts and tools available:
Phillips (+) screwdriver, number 2
2 wall-mount brackets (provided with the wall-mount kit)
12 wall-mount bracket screws (provided with the wall-mount kit)
4 mounting screws (8-32 x 1.25 in. or M4 x 30 mm) (not included)
Dust covers for ports (for EX4200-24F switches only; optional)
Hollow wall anchors capable of supporting the combined weight of two fully loaded
switches, up to 44 lb (20 kg) (not included)—if you are mounting the switch in sheetrock
(wall board with a gypsum plaster core) or in wall board not backed by wall studs
WARNING: When mounted in a vertical position, an EX4200 switch must be
oriented with the front panel of the chassis pointing down in order to ensure
proper airflow and meet safety requirements in the event of a fire.
NOTE: For easier lifting, install any additional power supplies only after you
mount the switch on the wall.
To mount the switch on a wall:
"Site Preparation Checklist
61.
243, with particular attention
252.
"Unpacking an EX4200 Switch" on
Copyright © 2017, Juniper Networks, Inc.