Juniper EX3300 Complete Hardware Manual page 31

Table 6: LCD Panel Menu Options (continued)
Menu Description
MAINT The Maintenance menu has the following options to configure and troubleshoot the switch:
(Maintenance
SYSTEM HALT?—Choose one of the following:
Menu)
Press the
Press the
SYSTEM REBOOT?—Choose one of the following:
Press the
Press the
LOAD RESCUE?—Choose one of the following:
Press the
to confirm the rollback.
Press the
REQUEST VC PORT?—Choose one of the following:
Press the
configuration.
NOTE:
configuration.
Press the
FACTORY DEFAULT?—Choose one of the following:
Press the
again to confirm the restoration.
Press the
ENTER EZSETUP?—Choose one of the following:
Press the
NOTE:
For information about EZSetup, see
on page
Press the
EXIT MAINT MENU?—Choose one of the following:
Press the
Press the
If you do not want users to use Maintenance menu options, disable the entire menu or individual menu options.
See Configuring the LCD Panel on EX Series Switches (CLI Procedure).
Related
Documentation
Copyright © 2015, Juniper Networks, Inc.
button to halt the switch. Press the
Enter
button to go to the next option in the Maintenance menu.
Menu
button to reboot the switch. Press the
Enter
Menu button to go to the next option in the Maintenance menu.
Enter button to roll back the switch to the rescue configuration. Press the
button to go to the next option in the Maintenance menu.
Menu
button to configure an uplink port in an EX3300 switch or to delete a VCP from the switch
Enter
This option is available only for an EX3300 switch that is a member of a Virtual Chassis
button to go to the next option in the Maintenance menu.
Menu
button to restore the switch to the factory default configuration. Press the
Enter
Menu button to go to the next option in the Maintenance menu.
button to launch EZSetup. Press the
Enter
You can use the ENTER EZSETUP option only if the switch is in the factory default configuration.
"Connecting and Configuring an EX Series Switch (J-Web Procedure)"
123.
button to go to the next option in the Maintenance menu.
Menu
button to exit the Maintenance menu. Then press the
Enter
button to go to the System Halt option.
Menu
Front Panel of an EX3300 Switch on page 6
Connecting and Configuring an EX Series Switch (CLI Procedure) on page 119
Chapter 2: Component Descriptions
button again to confirm the halt.
Enter
button again to confirm the reboot.
Enter
button again to confirm the launch.
Enter
button to go to the Idle menu.
Menu
Enter button again
button
Enter
15