Figure 43: Connecting A Fiber-Optic Cable To An Optical Transceiver Installed In - Juniper EX3300 Complete Hardware Manual

Complete Hardware Guide for EX3300 Ethernet Switches
Related
Documentation
114
To connect a fiber-optic cable to an optical transceiver installed in a switch:
WARNING: Do not look directly into a fiber-optic transceiver or into the ends
of fiber-optic cables. Fiber-optic transceivers and fiber-optic cables connected
to transceivers emit laser light that can damage your eyes.
If the fiber-optic cable connector is covered with a rubber safety cap, remove the cap.
1.
Save the cap.
Remove the rubber safety cap from the optical transceiver. Save the cap.
2.
Insert the cable connector into the optical transceiver (see
3.
Figure 43: Connecting a Fiber-Optic Cable to an Optical Transceiver
Installed in a Switch
Secure the cables so that they are not supporting their own weight. Place excess cable
4.
out of the way in a neatly coiled loop. Placing fasteners on a loop helps cables maintain
their shape.
CAUTION: Do not bend fiber-optic cables beyond their minimum bend
radius. An arc smaller than a few inches in diameter can damage the cables
and cause problems that are difficult to diagnose.
Do not let fiber-optic cables hang free from the connector. Do not allow
fastened loops of cables to dangle, which stresses the cables at the
fastening point.
Disconnecting a Fiber-Optic Cable from a Switch on page 132
Installing a Transceiver in an EX Series Switch on page 95
Maintaining Fiber-Optic Cables in Switches on page 135
Pluggable Transceivers Supported on EX Series Switches
Installing a Transceiver in an OCX1100 Switch
Pluggable Transceivers Supported on OCX1100 Switches
Figure 43 on page 114).
Copyright © 2015, Juniper Networks, Inc.