Juniper EX3300 Complete Hardware Manual page 117

Table 32: Parts and Tools Required for Connecting an EX Series Switch to Earth
Ground (continued)
Earthing
Terminal Grounding Cable
Switch Location Requirements
EX4300 Left side of 14 AWG (2 mm²),
chassis minimum 90°C wire,
or as permitted by
the local code
EX4500 Left side of 14 AWG (2 mm²),
chassis minimum 90°C wire,
or as permitted by
the local code
EX4550 Left side of 14 AWG (2 mm²),
chassis minimum 90°C wire,
or as permitted by
the local code
EX6210 Rear panel The grounding cable
of chassis must be the same
(on lower gage as the power
left side) feed cables and as
permitted by the
local code.
EX8208 Left side of 6 AWG (13.3 mm²),
chassis minimum 60°C wire,
or as permitted by
the local code
Copyright © 2015, Juniper Networks, Inc.
Grounding Lug Screws and
Specifications Washers
Panduit Two 10-32
LCC10-14BWL or x .25 in. screws
equivalent— with #10
not provided split-lock
washer—
not provided
Two #10 flat
washers—
not provided
Panduit Two 10-32
LCC10-14BWL or x .25 in. screws
equivalent— with #10
not provided split-lock
washer—
not provided
Two #10 flat
washers—
not provided
Panduit Two 10-32
LCC10-14BWL or x .25 in. screws
equivalent— with #10
not provided split-lock
washer—
not provided
Two #10 flat
washers—
not provided
Panduit Two ¼-20
LCD2-14A-Q or x 0.5 in. screws
equivalent with #¼"
—provided split-washer
—provided
Two #¼" flat
washers—
provided
Panduit Two ¼-20
LCD2-14A-Q or x 0.5 in. screws
equivalent with #¼"
—provided split-washer
—provided
Two #¼" flat
washers—
provided
Chapter 11: Connecting the Switch
Additional
Screwdriver Information
Phillips (+) See "Special
number 2 Instructions to
Follow Before
Connecting Earth
Ground to a Switch"
on page 102.
Phillips (+) See "Special
number 2 Instructions to
Follow Before
Connecting Earth
Ground to a Switch"
on page 102.
Phillips (+) See "Special
number 2 Instructions to
Follow Before
Connecting Earth
Ground to a Switch"
on page 102.
Phillips (+)
number 2
Phillips (+)
number 2
101