Figure 25: Attaching The Side Mounting-Rail To The Switch Chassis; Figure 26: Mounting The Switch To The Front Posts In A Rack - Juniper EX3300 Complete Hardware Manual

Copyright © 2015, Juniper Networks, Inc.

Figure 25: Attaching the Side Mounting-Rail to the Switch Chassis

Insert the 4x6-mm Phillips flat-head mounting screws into the remaining two holes
6.
in the side mounting-rails and tighten the screws.
Have one person grasp both sides of the switch, lift the switch, and position it in the
7.
rack, aligning the side mounting-rail holes with the threaded holes in the front post
of the rack. Align the bottom hole in both the front-mounting brackets with a hole in
each rack rail, making sure the chassis is level. See

Figure 26: Mounting the Switch to the Front Posts in a Rack

1— Side mounting-rail
Have a second person secure the front of the switch to the rack by using the appropriate
8.
screws for your rack.
Slide the rear mounting-blades into the side mounting-rails. See
9.
Chapter 9: Installing the Switch
Figure 26 on page
2— Front-mounting bracket
Figure 27 on page
89.
90.
89