Figure 38: Ethernet Cable Connector - Juniper EX3300 Complete Hardware Manual

Complete Hardware Guide for EX3300 Ethernet Switches
110
Ensure that you have an Ethernet cable with an RJ-45 connector available. One such
cable is provided with the device.
the Ethernet cable supplied with the device.

Figure 38: Ethernet Cable Connector

To connect a device to a network for out-of-band management (see
Figure 39 on page 111):
Connect one end of the Ethernet cable to the management port (labeled
1.
) on the device.
ETHERNET
For the location of the
MGMT
See EX2200 Switches Hardware Overview.
See Rear Panel of an EX3200 Switch.
See "Rear Panel of an EX3300 Switch" on page
See Rear Panel of an EX4200 Switch.
See EX4300 Switches Hardware Overview
See Front Panel of an EX4500 Switch.
See EX4550 Switches Hardware Overview
See Switch Fabric and Routing Engine (SRE) Module in an EX6200 Switch.
See Switch Fabric and Routing Engine (SRE) Module in an EX8208 Switch.
See Routing Engine (RE) Module in an EX8216 Switch.
See Front Panel of an XRE200 External Routing Engine.
See OCX1100 Switches Hardware Overview.
Connect the other end of the Ethernet cable to the management device.
2.
Figure 38 on page 110 shows the RJ-45 connector of
or port on different devices:
ETHERNET
7.
Copyright © 2015, Juniper Networks, Inc.
or
MGMT